SDI-16 SDI slip ring 16 electrical circuit

SDI-16 SDI slip ring 16 electrical circuit

♦Compact miniature design ,small size fit for harsh space

♦Moudel design ; Meet the most of rquirement

♦Combine slip ring and RF Joint

♦Can combine high speed data HD vedio signal and power in same slip ring

♦Meet the requirement of industrial field

¤ Typical Application

♦CCTV Monitoring System

♦Electrical test equipment

♦Medical equipment

♦Robotics

Installation Guide:

Picture A
1.Position the slip ring in the desired location and tighten both set screws to the shaft.Maximum torque 25Ib-in(DO NOT OVER TORQUE)
2.Route the wiring and make the neccessary connections.Do not allow the wiring to restrict free rotation of the slip ring.Do not constrain wiring such that wire flexing occurs.Doing so will ultimately cause failure(breakage of the wiring).

Picture B
1.Align the mouting holes(M3X8)in the flange to mouting base and install mouting screws(M3),securely tighten screws.
2.Route the wiring and make neccessary connections.Do not allow the wiring to restrict free rotation of the slip ring.

CAUTION:
Because of possible geometric mismatching between the customer's application and the slip ring,'hard mouting'of both ends of the slip ring(i.e.securing the rotor and stator such that there is no floating during operation) is not recommended and may cause premature failure.

SDI-16 SDI slip ring 16 electrical circuit Images